Pure Electric servo CNC bending machine – PS series

Advantages of pure electric bending machine

Taking a month's electricity consumption as a reference, the electricity consumption of pure electric servo models in a

month is only 30%-50% of that of electro-hydraulic servo models.

pure electric servo CNC bending machine does not use hydraulic oil, so there is no oil leakage and other pollution caused by oil.

Compared with the same model of electro-hydraulic model, the efficiency will be increased by 50%-80%.

Compared with the electro-hydraulic model of the same model, the bending accuracy can be increased by 20%-50%.

Clean - Electric drive, does not require hydraulic oil
Energy Saving - Save about 70% energy compared to traditional machines
Quiet - No vibration during operation, noise and sound pressure ≤ 40dB
Precision - Reduce accuracy interference points by approximately 60%
Efficient - Direct drive servo motor with high response speed
Hedging - Zero fault, long service life

High efficiency, Double the efficiency 

Pure electric servo CNC bending machine fast full speed conversion and lower dead center positioning are controlled by servo motor and screw, the whole cycle of control is much faster than hydraulic bending machine. Compare with the same model of electro-hydraulic models, the efficiency will be doubled. 

Accuracy, Always accurate 

Pure electric servo CNC bending machine mainly relies on servo motor and screw drive to make the slide up and down movement and positioning, long-term use, positioning accuracy con still be maintained, The electro-hydraulic model mainly relies on oil pressure transmission to make the slider up and down, with the oil temperature changes, the positioning accuracy of its slider will also decline, with the resulting repeat positioning accuracy will be difficult to ensure.

Low cost of maintenance and use

Hydraulic bending machine hydraulic oil needs to be replaced regularly, pumps, valves and seals are prone to failure, easy to damage, the hydraulic system is easy to contaminate, fault finding and troubleshooting difficulties, once the hydraulic system pollution, cleaning the system is difficult, and all will cause environmental pollution.  Pure electric servo bending machine drive system is simple, basically no maintenance costs, only need regular lubrication.

Main Component configuration